What the Studio Actually Looks Like
A converted storefront on Westminster Street, downtown Providence — three rooms, no waiting area with a TV bolted to the wall, because the fitting bay is the thing worth showing.
The Fitting Bay
A single hitting stall with the dual-radar launch monitor mounted overhead and a torque-reading rig set up beside the mat, so both readings happen without moving between rooms.
The Build Bench
Visible from the bay through an open doorway rather than tucked in the back — you can watch a shaft actually get pulled, torque-checked, and installed if the fitting runs into a same-day build.
The Component Wall
Heads and shafts organized by category along the back wall, each tagged with its measured torque rating rather than just the manufacturer's stock spec sheet number.
Street-Level, Downtown Providence
Ground-floor storefront on Westminster Street, a few blocks from Kennedy Plaza, in a stretch that's mostly small independent shops rather than a strip-mall setting. Street parking is metered during the day; a public garage two blocks over is the easier bet on a weekday afternoon.
Stop In Without an Appointment
If you'd rather see the bay before committing to a fitting slot, weekday afternoons are usually the quietest time to stop by and take a look. There's no obligation attached to a walk-through, and it's a normal enough request that the front desk won't blink at it.
Ready to Book a Session?
Once you've seen the setup, booking a fitting is the same process either way.